Ip Address - Allied Telesis AT-8100L/8 User Manual

IP ADDRESS

Syntax
ip address ipaddress/mask
Parameters
ipaddress
Specifies an IPv4 address for a new routing interface. You may
specify only one IP address. The address must be a unique
member of the network in which the interface is to reside. The
address is specified in this format:
nnn.nnn.nnn.nnn
Where each NNN is a decimal number from 0 to 255. The numbers
must be separated by periods.
mask
Specifies the subnet mask for the address. The mask is a decimal
number that represents the number of bits, from left to right, that
constitute the network portion of the address. For example, the
IPv4 decimal masks 16 and 24 are equivalent to masks
255.255.0.0 and 255.255.255.0, respectively.
Mode
VLAN Interface mode
Description
Use this command to create IPv4 routing interfaces with static IP
addresses. You can create only one routing interface at a time with this
command. A VLAN can have only one routing interface. To create routing
interfaces that have dynamic addresses from a DHCP server, refer to "IP
ADDRESS DHCP" on page 1831.
Confirmation Command
"SHOW IP INTERFACE" on page 1841
AT-8100 Switch Command Line User's Guide
1829