Disabling A Port; Table 245. Setting Storm Control Action: Disabling A Port - Allied Telesis AT-8100L/8 User Manual

Table 244. Setting Storm Control Action: Disabling a VLAN (Continued)
Command
awplus(config-cmap)# match
vlan 2
awplus(config-cmap)# exit
awplus(config)# policy-map
pmap3
awplus(config-pmap)# class
cmap2
awplus(config-pmap-c)# storm-
protection
awplus(config-pmap-c)# storm-
action vlandisable
awplus(config-pmap-c)# exit
awplus(config-pmap)# exit
awplus(config)# interface
port1.0.7
awplus(config-if)# service-
policy input pmap3

Disabling a Port

Table 245. Setting Storm Control Action: Disabling a Port

Command
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# policy-map
pmap2
The following example sets the storm protection action to disable the port
assigned to the policy map named "pmap2." The STORM-ACTION
command set to "portdisable" disables the port in software without
physically disabling the port. See Table 245.
AT-8100 Switch Command Line User's Guide
Description
Configures the class map to include
traffic from VLAN 2.
Exits the Class Map mode and returns to
the Global Configuration mode.
Creates a policy map called "pmap3" and
enters the Policy Map mode.
Associates class map "cmap2" to policy
map "pmap3" and enters the Policy Map
Class mode.
Enables the QSP feature.
Sets the storm action to remove a port
from VLAN 2.
Exits the Policy Map Class mode and
enters the Policy Map mode.
Exits the Policy Map mode and enters
the Global Configuration mode.
Enters the Port Interface mode for port 7.
Assigns a policy map "pmap3" to port 7.
Description
Enters the Privileged Executive mode
from the User Executive mode.
Enters the Global Configuration mode.
Activates the QoS feature on the switch.
Creates a policy map called "pmap2" and
enters the Policy Map mode.
1787