Table 213. Configuring A Single-Rate Policer; Table 214. Configuring A Twin-Rate Policer - Allied Telesis AT-8100L/8 User Manual

Chapter 100: Quality of Service (QoS)
Command
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap3
awplus(config-pmap-c)# police
single-rate 10000 14000 20000 action
drop-red
Command
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap3
awplus(config-pmap)# class cmap4
1658
Creating a Single-rate Policer
The following example configures a single-rate policer requiring traffic to
conform to a CIR of 10,000 Kbps, a CBS of 14,000 bytes, and an Excess
burst size of 20,000 bytes. This policer drops traffic that does not conform
to the set conditions.

Table 213. Configuring a Single-rate Policer

Creating a Twin-rate Policer
The following example configures a twin-rate policer requiring traffic to
conform to a CIR of 10,000 Kbps, a PIR of 20,000 Kbps, a CBS of 30,000
bytes, and a PBS of 50,000 bytes. This policer remarks traffic if it does not
conform to the set conditions.

Table 214. Configuring a Twin-rate Policer

Description
Enters the Privileged Executive mode from the
User Executive mode.
Enters the Global Configuration mode.
Creates a policy map "pmap2" and enters the
Policy Map Configuration mode.
Associates an existing class map "cmap3" to the
policy map and enters the Policy Map Class
Configuration mode.
Configures a single-rate meter measuring traffic at
10,000 Kbps and a Committed Burst Size (CBS) of
14,000 bytes that drops traffic bursting over 20,000
bytes.
Description
Enters the Privileged Executive mode from the
User Executive mode.
Enters the Global Configuration mode.
Creates a policy map "pmap3" and enters the
Policy Map Configuration mode.
Associates an existing class map "cmap4" to the
policy map and enters the Policy Map Class
Configuration mode.