Ip Rip Send-Packet - Allied Telesis AT-8100L/8 User Manual

AT-8100 Switch Command Line User's Guide

IP RIP SEND-PACKET

Syntax
ip rip send packet
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to enable the routing interfaces in VLANs to send
routing updates. You can configure only one routing interface at a time
with this command.
Confirmation Command
"SHOW RUNNING-CONFIG" on page 164
Example
The following example configures the routing interface in VLAN 3 to send
routing updates:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# ip rip send-packet
1869