Storm-Action - Allied Telesis AT-8100L/8 User Manual

Chapter 103: QSP Commands

STORM-ACTION

1796
Syntax
portdisable|vlandisable|linkdown
storm-action
Parameters
portdisable
Disables the port in software.
vlandisable
Removes the port from the VLAN. This parameter requires that the
MATCH VLAN command is present in a class-map. See "MATCH
VLAN" on page 1624.
linkdown
Shuts down the port. In other words, turns off the port on the
switch.
Mode
Policy Map Class
Description
Use this command to set the action triggered by QoS Storm Protection
(QSP). All three options disable a port in some way. To determine the
amount of time that the port is disabled, use the STORM-DOWNTIME
command. See "STORM-DOWNTIME" on page 1798.
Use the no form of the command, NO STORM-ACTION, to disable the
action set by the STORM-ACTION command.
Confirmation Command
"SHOW MLS QOS INTERFACE STORM-STATUS" on page 1794
Examples
The following example sets the storm protection action to block incoming
packets on port 17 from VLAN 5 when a packet storm occurs:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# class-map cmap1
awplus(config-cmap)# match vlan 5
awplus(config-cmap)# exit