Allied Telesis AT-8100L/8 User Manual page 1825

awplus(config)# router rip
awplus(config-router)# network vlan4
awplus(config-router)# passive-interface vlan4
awplus(config-router)# network vlan5
awplus(config-router)# passive-interface vlan5
awplus(config-router)# network vlan11
awplus(config-router)# passive-interface vlan11
awplus(config-router)# network vlan15
You may specify the interfaces in the NETWORK command by their
respective network addresses instead of their VLAN IDs. This is illustrated
in this command, which activates RIP on VLAN 4:
awplus(config-router)# network
For further information on RIP, refer to Chapter 106, "Routing Information
Protocol (RIP)" on page 1845 and Chapter 107, "Routing Information
Protocol (RIP) Commands" on page 1859.
AT-8100 Switch Command Line User's Guide
Enter the Router Configuration
mode.
Activate RIP on VLAN 4 to include
its network address in the RIP
update packets.
Configure RIP in VLAN 4 not to
send update packets.
Activate RIP on VLAN 5 to include
its network address in the RIP
update packets.
Configure VLAN 5 not to send RIP
update packets.
Activate RIP on VLAN 11 to
include its network address in the
RIP update packets.
Configure VLAN 11 not to send
RIP update packets.
Activate RIP on VLAN 15 to
include its network address in the
RIP update packets. (Do not
perform the PASSIVE-
INTERFACE command on this
VLAN because it is to transmit RIP
update packets to its RIP
neighbor.)
149.35.67.0/24
1825