Finisher Punch Communications Failure - Xerox Paser 7400 Service Manual

Finisher Punch Communications Failure

An communications error occurred with the Punch Unit.
Applicable Status Code:
Code F132:
Punch Unit communications failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Control Board
Punch Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the connection between the Finisher
and Punch Controller Boards.
Are CN12 and CN14 on the Finisher
Control Board connected?
Are P/J2003 and P/J2004 on the Punch
Control Board connected?
2
Check all the pins of the harness for
continuity.
Is the cable conductive?
3 Check for +24 V at the Finisher Control
Board.
Is there +24 V at CN14-5 <=> CN14-3?
3-62
Wiring and Plug/Jack References
Print Engine Motor Driver Board (6/6) (see Book 1)
Options Map 2 Punch Controller Board
Phaser 7400 Color Printer Options Service Manual
Yes
Go to Step 2.
Go to Step 3.
Replace the Punch
Control Board
(page 5-50).
No
Connect the
harness.
Replace the
harness.
Replace the
Finisher Control
Board (page 5-46).