Output Tray Is Full, Unload Paper - Xerox 6200B - Phaser Color Laser Printer Service Manual

Output Tray is Full, Unload Paper

The printer's front panel displays "Output Tray is Full, Unload Paper". The output
tray has been emptied of all paper, printer power has been cycled and the message
still appears.
Troubleshooting Reference Table
Applicable Parts
Actuator Kit, PL 6.1.5
Full Stack Sensor, PL 6.1.4
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following for evidence of fault
or damage:
Actuator, Full Stack PL 6.1
Full Stack Sensor PL 6.1
2 Use service diagnostics to test the Full
Stack Sensor.
Does the sensor function correctly?
3 Replace the Full Stack Sensor.
Does the sensor report an error once
replaced?
4 Troubleshoot the wiring using the wiring
diagram "Paper Feed" on page 362.
58
Wiring and Plug/Jack Map References
"Paper Feed" on page 362
Phaser 6200 Color Laser Printer - Service Manual
Yes
Replace the parts
concerned.
Replace Engine
Control Board,
RRP 12.7
Go to step [4].
Replace defective
parts.
No
Go to step [2].
Go to step [3].
Complete
Replace Engine
Control Board,
RRP 12.7.