Finisher Stack Handling Motor Failure - Xerox Paser 7400 Service Manual

Finisher Stack Handling Motor Failure

The Delivery Belt Home Position Sensor detected a Stack Handling error.
Applicable Status Code:
Code F111:
Stack Handling Motor Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Stack Handling Motor
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the delivery mechanism.
Does the Delivery Belt turn freely when
operated manually?
2 Test the Delivery Belt Home Position
Sensor.
Run the Service Diagnostics Exit Belt
Home Position Sensor test.
Does the sensor operate?
3 Test the Staple Motor.
1. Close the Interlock Switches for test.
2. Run the Service Diagnostics Staple
Motor tests.
Does the motor operate?
4 Check for +24 V to the Staple Motor.
Disconnect CN59.
Is there +24 V across CN59-1 and -2 <=>
ground?
5 Check all pins of the Inverter Interface
Cable for continuity.
Disconnect CN1 and CN2 from the Finisher
Control Board and the opposite end from
the Inverter.
Is the cable conductive?
General Troubleshooting
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Finisher Controller to Motors
Yes
Go to Step 2.
Go to Step 3.
Replace the
Finisher Control
Board (page 5-46).
If the error persists,
go to Step 4.
Replace the Stack
Handling Motor
(page 5-60).
Replace the Inverter
Power Supply
(page 5-56).
No
Repair the
mechanism.
Replace the
sensor. If the error
persists, go to
Step 3.
Go to Step 4.
Replace the
harness. If the
error persists, go
to Step 5.
Replace the cable.
3-55