Finisher Exit Failure - Xerox Paser 7400 Service Manual

Finisher Exit Failure

The Delivery Belt Home Position Sensor detected a Delivery Motor error.
Applicable Status Code:
Code F116:
Delivery Motor Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Delivery Motor
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1
Test the Exit Motor.
1. Close the Interlock Switches for test.
2. Run the Service Diagnostics Finisher
Bundle Motor tests.
Does the motor operate?
2 Check for +24 V to the Exit Motor.
Disconnect CN59.
Is the +24 V across CN59-1 and -2 <=>
ground?
3 Check Finisher Control Board for +24 V.
1. Disconnect CN13 on the Finisher
Control Board.
Is the +24 V across CN13-1 and -2?
4 Check the Inverter Interface Cable for
continuity.
Disconnect CN1 and CN2 from the Finisher
Control Board and the opposite end from
the Inverter.
Is the cable conductive?
3-60
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Finisher Controller to Motors
Phaser 7400 Color Printer Options Service Manual
Yes
Complete.
Replace the Exit
Motor (page 5-64).
Replace the Exit
Motor Harness.
Replace the Inverter
Power Supply
(page 5-56).
No
Go to Step 2.
Go to Step 3.
Replace the
Finisher Control
Board (page 5-46).
If the error
persists, go to
Step 4.
Replace the cable.