Inverter Upper Roller Solenoid
1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Remove the Inverter Rear Covers (page 5-19).
3.
Remove the Top Cover (page 5-23).
4.
Disconnect the cable from the connector (CL2) on the Inverter Controller Board.
Be sure you also free the cable harness from the cable guide.
5.
Carefully remove the tension spring from the solenoid and swing plate.
6.
From the chassis side, carefully free the paper guide from the swing plate.
7.
Remove two screws (metal flange, 6 mm) from the solenoid casing.
8.
To remove the solenoid unit, remove two small brass screws (metal, 4 mm) from
the solenoid casing and lift the relay from the casing.
5-70
Phaser 7400 Color Printer Options Service Manual
Upper Roller Solenoid
s7400-498