Table of Contents
Advertisement
Delivery Belt Home Position Sensor
The Delivery Belt Home Position Sensor detects the end location of the delivery
rollers (sensor is off). To remove and replace the Delivery Belt Home Position
Sensor:
1.
Remove the Paper Exit Tray (page 5-7).
2.
Remove the Front Door (page 5-8).
3.
Remove the Rear Cover (page 5-11).
4.
Remove the Upper Cover (page 5-13).
5.
Remove the Side Guide (page 5-107).
6.
To locate the sensor, manually rotate the delivery roller belts. You will see the
activator (which is attached to the belt) trip the sensor.
7.
To remove the sensor, first remove the 4-wire connector CN31 from the sensor.
Using small needle nose pliers, pinch the plastic tabs to pull one side of the
sensor free.
5-90
Delivery Belt
Home Position Sensor
Phaser 7400 Color Printer Options Service Manual
Tray Paper Sensor
s7400-708
Advertisement
Table of Contents
Troubleshooting
