Duplex Unit Sensors and Switches
There are a total of five sensors for the various duplex interlocks and paper paths.
Refer to the sensor locator illustration to locate the appropriate sensor. To remove any
of the sensors:
1.
Remove the Front Cover Assembly (page 5-122).
2.
Disconnect the sensor connector (either SNSCN0 or SNSCN1) from the Duplex
Unit Controller Board.
3.
Pinch the plastic insert pins on the connector together and lift free from the
chassis.
Caution
Be careful not to lose any of the retainer springs.
Duplex Entrance Sensor
Duplex Reverse
Sensor
Duplex Front Sensor
5-130
Duplex Rear Sensor
Phaser 7400 Color Printer Options Service Manual
Paper End Sensor
s7400-676