Paper Surface Sensor
The Paper Surface Sensor detects media in the home position of the delivery tray. To
remove and replace the Paper Surface Sensor:
1.
Remove the Paper Exit Tray (page 5-7).
2.
Remove the Front Door (page 5-8).
3.
Remove the Rear Cover (page 5-11).
4.
Remove the Upper Cover (page 5-13).
5.
Remove the Side Guide (page 5-107).
6.
To locate the sensor, look through the top of the side area (where you removed
the Side Guide) and press the paper surface activator a few times (see
illustration). You will see the activator as it enters the sensor below.
Paper Surface Sensor
7.
To remove the sensor, first remove the 4-wire connector CN35 from the sensor,
and then, using small neediness pliers, pinch the plastic tabs to pull one side of
the sensor free.
Service Parts Disassembly
Processing Tray Sensor
s7400-701
5-77