Close Finisher Door F - Xerox Paser 7400 Service Manual

Close Finisher Door F

The Door F Interlock Switch indicates that Door F is open.
Initial Actions:
Ensure that the door is free of obstructions and fully closed.
Verify that the actuator is not broken.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Door F Interlock Switch and actuator
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Door F Interlock Switch
Switch actuator
2 Test the Door F Interlock Switch.
NOTE: Door sensor tests are located under
the Interlock Switches sub-menu.
Run the Service Diagnostics Front Door
Switch test.
Does the switch function correctly?
3 Check the switch connection.
Is CN68 connected?
4 Check all pins on the harness for continuity.
Disconnect the Switch harness from CN8.
Is the harness conductive?
5 Replace the Door F Interlock Switch.
Does the error persist?
General Troubleshooting
Wiring and Plug/Jack References
Options Map 9 Inverter Sensor Locations
Options Inverter Sensors Diagram
Yes
Replace the parts
concerned.
Replace the Engine
Control Board (see
Book 1).
Go to Step 4.
Go to Step 5.
Replace the
Finisher Control
Board (page 5-46).
No
Go to Step 2.
Go to Step 3.
Connect the
switch.
Replace the
harness.
Complete
3-35