Unsupported Finisher Unit Rom - Xerox Paser 7400 Service Manual

Unsupported Finisher Unit ROM

The printer has detected an incompatible Finisher.
Applicable Status Code:
Code U55:
Unsupported Finisher Unit ROM
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Finisher firmware version using
the Service Diagnostics General Status
menu.
General Troubleshooting
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Yes
Replace the Engine
Control Board (see
Book 1)
No
Replace the
Finisher Control
Board (page 5-46).
3-51