Duplex Unit Disassembly
To view sensors, motors, solenoids, gears, belts, and boards in the Duplex Unit, you
must first remove the following:
Front Cover Assembly
Bottom Plate
Side Rails
Note
If you need to remove the Duplex Unit Controller Board for any of the following
procedures, disconnect all connectors and remove one screw (self tapping, 6 mm)
securing the board to the frame, and then pull free from the mounting post.
Front Cover Assembly
From the front assembly, you can see three sensors and the connector to the Duplex
Unit Controller board. To remove the Front Cover assembly:
1.
Remove two screws (metal flange, 6 mm) from the front cover.
Duplex Unit Front Cover
5-122
Phaser 7400 Color Printer Options Service Manual
s7400-612