Stapler Safety Interlock Switch - Xerox Paser 7400 Service Manual

Stapler Safety Interlock Switch

The Stapler Safety Interlock Switch protects current overloads in case of a staple jam.
This switch will open to remove voltage from the stapler unit. To remove and replace
the switch:
1. Remove the Paper Exit Tray (page 5-7).
2. Remove the Front Door (page 5-8).
3.
Remove the Rear Cover (page 5-11).
4.
Remove the Upper Cover (page 5-13).
5.
Locate the Paddle Motor and Staple Safety Switch (see illustration).
6.
Slide the small belt from the Paddle Motor.
7. Remove two screws (metal, 6 mm) and washers from the motor casing and pull
the motor away from the chassis so that you have access to the switch.
8. Lift connector CN66 off of the two connector pins. You may need to free the two
wires from the cable harness.
9.
Remove the single screw (metal, 6 mm) holding the switch to the chassis.
10.
To remove the switch, release the three plastic hooks securing the switch to the
plastic.
5-92
Staple Safety
Interlock Switch
Phaser 7400 Color Printer Options Service Manual
s7400-675