Inverter Rear Covers
1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Press the release latch and slide the Finisher away from the printer.
3.
Remove two screws (metal flange, 10 mm) holding the Lower Rear Cover to the
chassis.
4.
Remove the Lower Rear Cover.
5.
Remove one screw (metal flange, 10 mm) from the left side and one screw from
the right side of the Upper Rear Cover.
6.
Remove two inset screws (metal flange, 10 mm) near the bottom of the Upper
Rear Cover.
7.
Remove one screw (metal flange, 10 mm) from the bottom of the Upper Rear
Cover.
Service Parts Disassembly
Lower Rear Cover
s7400-489
5-19