Standard Output Tray Is Full. Unload Paper - Xerox 4400DT - Phaser B/W Laser Printer Service Manual

Envelope Feeder Failure Troubleshooting Procedure (cont'd.)
Step Actions and Questions
3 1. Switch the Printer power OFF.
2. Remove the Envelope Feeder.
3. Check for continuity between J418 Pin 3 (Envelope
Connector Assembly) and P/J23 Pin 4 on the Engine
Logic Board.
Is there continuity between the two pins?
4 1. Remove the Front Cover (RRP 1.6 on
and the Left Front Cover (RRP 1.7 on
2. Check for continuity between P/J 41 Pin 6 on the
Connector PWB and P/J 23 Pin 4.
Is there continuity between the two pins?
5 Check the Connector Harness Assembly for proper
connection and for defective wires.
Is the Harness in good condition?

Standard Output Tray is Full. Unload Paper.

(Standard Output Tray Full)
Error message indicates the output tray is full.
Output Tray Full Troubleshooting Procedure
Step Actions and Questions
Is there a paper stack in the standard bin
1
actuating the Output Tray Full Sensor?
2 Is the paper curled?
3 Lift and release the Output Tray Full Actuator a few
times.
Does the actuator move freely?
4 Replace paper in paper tray with fresh dry paper. Run
test prints.
Does the error code reappear?
2-38
Yes
Replace the
Envelope
Feeder PWB
(RRP 13.3 on
page
page 6-11) Replace the
page 6-12).
Envelope
Connector
Assembly
(RRP 4.10 on
page
Replace the
Connector
PWB (RRP
9.7 on
page
Yes
Remove the
paper stack.
Go to step 4.
Go to step 5.
Go to step 5.
Phaser 4400 Laser Printer Service Manual
No
Go to step 4.
6-159).
Go to step 5.
6-56).
Repair or
replace if
necessary.
6-94).
No
Go to step 2.
Go to step 3.
Replace
Output Tray
Full Actuator
(RRP 6.8 on
page 6-76)
or Output
Tray Full
Sensor (RRP
6.6 on
page 6-72),
as
necessary.
Problem
solved.