Finisher Output Tray Jammed - Xerox Paser 7400 Service Manual

Finisher Output Tray Jammed

This error represents a failure of, or an obstruction in the Finisher Upper Output
Tray's up or down motion.
Applicable Status Code:
Code FT: Finisher Output Tray Jammed
Initial Actions:
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Lift Motor
Lift Motor Clock Sensor
Upper or Lower Limit Sensors
Lift Belts
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault,
damage, obstruction, or debris:
Upper Output Tray
Lift belts and actuators
Limit Sensors
Shift Motor
Are there any defects or misalignment?
2 Test the Limit Sensors.
Run the Service Diagnostics Tray Upper
and Lower Limit Sensor tests.
Do the sensors function correctly?
3
Test the sensor signals.
Does the voltage change on CN15-12
(Upper) and CN-15-9 (Lower) connector of
the Finisher Control Board when the
sensors are actuated?
4
Test the Shift Motor.
Run the Service Diagnostics Shift Motor
test.
Does the motor function correctly?
General Troubleshooting
Wiring and Plug/Jack References
Options Map 7, Finisher Sensor Locator (1/2)
Options Map 8, Finisher Sensor Locator (2/2)
Options Finisher Controller to Sensors (2/3)
Options Finisher Controller to Switches
Yes
Replace any
damaged parts.
Go to Step 4.
Replace the
Finisher Control
Board (page 5-46).
Go to Step 4.
No
Go to Step 2.
Replace the
affected sensor. If
the error persists,
go to Step 3.
Replace the
harness.
Replace the motor.
3-31