Finisher Inverter Firmware Error - Xerox Paser 7400 Service Manual

Finisher Inverter Firmware Error

Applicable Status Code:
Code 227:
A software error with the Inverter's Flash Memory.
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Inverter Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Inverter Interface Cable
Inverter connections
Is there any damage?
2 Check the Inverter connection.
Is the Inverter interface cable securely
connected at both ends?
3 Check the version of Inverter firmware.
Is the latest version installed?
3-74
Wiring and Plug/Jack References
Print Engine Map 3 (see Book 1)
Print Engine Motor Driver Board (6/6) (see Book 1)
Options Map 3 Inverter Controller Board
Phaser 7400 Color Printer Options Service Manual
Yes
Replace any
damaged parts.
Go to Step 3.
Replace the Inverter
Control Board
(page 5-55).
No
Go to Step 2.
Connect the
Inverter to the
Finisher.
Reload the Inverter
firmware.