Door C Detect Sensor - Xerox Paser 7400 Service Manual

Door C Detect Sensor

The Door C Detect Sensor is mounted on a carrier located beneath the Registration
Rollers near the clutch.
Caution
Use care when removing the roller shaft bearings. The bearings use a small clip
to lock into a notch near the end of each roller shaft. Use a small, flat-bladed
screwdriver to release the clip from the shaft before attempting to remove the
bearing.
1.
Remove the Tray 2 Feeder (page 5-136).
2.
Remove the Registration Clutch #2 (page 5-140).
3. Remove the 2 springs that tension the Registration Rollers.
4. Remove the bearings at each end of the rubber roller, and then remove the roller.
Tray 3 Feeder Assembly
5.
Release the hook that secures the sensor carrier to the feeder.
6.
Turn the sensor carrier over, and then release the hooks that secure the sensor to
the carrier.
7.
Disconnect the sensor connector (P/J41).
Service Parts Disassembly
Rubber Registration Roller
Retainer Clip
s7400-683
5-141