Staple/Fold Clock Sensor - Xerox Paser 7400 Service Manual

Staple/Fold Clock Sensor

The Staple/Fold Clock Sensor counts timing pulses during staple and fold operations.
To remove the sensor:
1. Remove the Paper Exit Tray (page 5-7).
2. Remove the Rear Cover (page 5-11).
3.
Locate the sensor (see illustration) and disconnect connector CN52.
Staple/Fold
Motor
4.
To remove the sensor, pinch the plastic tabs with needle nose pliers, and then pull
the sensor free.
Service Parts Disassembly
CN71
CN52
Staple/Fold
Clock Sensor
Edge Saddle
s7400-229
5-93