Output Tray Is Full, Unload Paper; Cycle Printer Power; If The Problem Persists, Follow The Procedure Below - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Output Tray is Full, Unload Paper

■
Ensure that the ouput tray is empty.
■
Ensure that the output tray full flag is in the correct position.
■

Cycle printer power.

■

If the problem persists, follow the procedure below.

Troubleshooting Reference Table
Applicable Parts
Actuator Kit, PL 6.1.5
Full Stack Sensor, PL 6.1.4
Troubleshooting Procedure Table
Steps Actions and Questions
Check the following for evidence of fault
1
or damage:
Actuator, Full Stack PL 6.1.5
Full Stack Sensor PL 6.1.4
Use service diagnostics to test the Full
2
Stack Sensor.
Does the sensor function correctly?
Replace the Full Stack Sensor.
3
Does the sensor report an error once
replaced?
Troubleshoot the wiring using the wiring
4
diagram "Paper Feed" on page 10-25.
3-48
Wiring and Plug/Jack Map References
"Paper Feed" on page 10-25
"Paper Feed" on page 10-25
Phaser 6250 Color Laser Printer Service Manual
Yes
Replace the parts
concerned.
Replace Engine
Control Board,
page 8-107
Go to Step 4.
Replace defective
parts.
No
Go to Step 2.
Go to Step 3.
Complete
Replace Engine
Control Board,
page 8-107.