Jam At Finisher Upper Output Tray - Xerox Paser 7400 Service Manual

Jam at Finisher Upper Output Tray

Media remains in the Finisher offset rollers. This error represents a jam in the Finisher
upper output path.
Applicable Status Code:
Code FN6:
Jam at Finisher Upper Output Tray
Initial Actions:
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Compiler Tray
Front and Rear Alignment Guides
Transport Rollers
Stapler
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Compiler Tray
Front and Rear Alignment Guides
Transport Rollers
Stapler
Are there any defects or misalignment?
2 Test the Processing Tray Sensor.
Run the Service Diagnostics sensor test.
Does the sensor function correctly?
3 Check the Processing Tray Sensor signal
at the Finisher Control Board.
Actuate the sensor.
Does the voltage across CN5-3 <=>
ground change when the sensor is
actuated?
3-24
Wiring and Plug/Jack References
Options Map 7, Finisher Sensor Locator (1/2)
Options Map 8, Finisher Sensor Locator (2/2)
Options Finisher Controller to Sensors (1/3)
Options Finisher Controller to Sensors (2/3)
Phaser 7400 Color Printer Options Service Manual
Yes
Replace any
damaged parts.
Replace the Engine
Control Board (see
Book 1).
Replace the
Finisher Control
Board(page 5-46).
No
Go to Step 2.
Replace the
sensor. If the error
persists, go to
Step 3.
Replace the
harness.