Finisher Paddle Failure - Xerox Paser 7400 Service Manual

Finisher Paddle Failure

An error was detected in the Finisher Paddle Motor.
Applicable Status Code:
Code F103:
Paddle Motor failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Finisher Paddle Motor
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Test these sensors.
Swing Guide Home Position
Sensor
Paddle Home Position Sensor
Run the appropriate Service Diagnostics
sensor test.
Do the sensors operate?
2 Test the Paddle Motor.
1. Close the Interlock Switches for test.
2. Run the Service Diagnostics Paddle
Motor test.
Does the motor operate?
3
Check for +24 V to the Paddle Motor.
Disconnect CN57.
Is there +24 V across CN57-1 and -2 <=>
ground?
4 Check all pins of the Inverter Interface
Cable for continuity.
Disconnect CN1 and CN2 from the Finisher
Control Board and the opposite end from
the Inverter.
Is the cable conductive?
General Troubleshooting
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Finisher Controller to Motors
Yes
Go to Step 2.
Replace the
Finisher Control
Board (page 5-46).
If the error persists,
go to Step 4.
Replace the
Delivery Motor
(page 5-64).
Replace the Inverter
Power Supply
(page 5-56).
No
Replace the
sensor. If the error
persists, go to
Step 2.
Go to Step 4.
Replace the
harness. If the
error persists, go
to Step 5.
Replace the cable.
3-53