Inverter Controller Board - Xerox Paser 7400 Service Manual

Inverter Controller Board

1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Remove the Inverter Rear Covers (page 5-19).
3. Disconnect all cables.
Replacement Note
It is a good idea to label all connectors to make sure that you replace each
one in its proper plug during reassembly.
4. Remove the two top screws (metal flange, 6 mm) securing the board to the
chassis. It is not necessary to remove the lower left screw.
5. Lift the board up to free it from the slots before you pull it out of the chassis.
Service Parts Disassembly
Inverter Controller Board
s7400-499
5-55