Lift Motor Clock Sensor - Xerox Paser 7400 Service Manual

Lift Motor Clock Sensor

The Lift Motor Clock Sensor detects clock pulses for the stacking operation. To
remove and replace the sensor:
1. Remove the Paper Exit Tray (page 5-7).
2. Remove the Rear Cover (page 5-11).
3.
Remove the Upper Cover (page 5-13).
4. Remove the Side Guide (page 5-107).
5. Remove 4 screws (metal flange, 6 mm) holding the metal cover box to the
chassis, and one screw (metal flange, 6 mm) attaching the large harness to the
metal cover box.
6. Turn the box so that you can view the sensor.
Lift Motor Clock Sensor
7.
To remove the sensor, first remove the 4-wire connector (CN48) from the sensor.
Using small needle nose pliers, pinch the plastic tabs to pull the sensor free.
5-80
Lift Motor
Phaser 7400 Color Printer Options Service Manual
Lift Motor Cover Box
s7400-667