Output Tray is Full, Unload Paper
■
Ensure that the ouput tray is empty.
■
Ensure that the output tray full flag is in the correct position.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Actuator Kit, PL 6.1.5
Full Stack Sensor, PL 6.1.4
Troubleshooting Procedure Table
Steps
Actions and Questions
1
Check the following for evidence of fault
or damage:
Actuator, Full Stack PL 6.1.5
Full Stack Sensor PL 6.1.4
2
Use service diagnostics to test the Full
Stack Sensor.
Does the sensor function correctly?
3
Replace the Full Stack Sensor.
Does the sensor report an error once
replaced?
4
Troubleshoot the wiring using the wiring
diagram "Paper Feed" on page 10-25.
3-48
Wiring and Plug/Jack Map References
"Paper Feed" on page 10-25
"Paper Feed" on page 10-25
Phaser 6250 Color Laser Printer Service Manual
Yes
Replace the parts
concerned.
Replace Engine
Control Board,
page 8-107
Go to Step 4.
Replace defective
parts.
No
Go to Step 2.
Go to Step 3.
Complete
Replace Engine
Control Board,
page 8-107.