Removing And Fastening The Seat Cushion; Removing And Fastening The Back Support Pad; Backrest - Otto Bock Start M4 XXL Instructions For Use Manual

Use

7.4.1 Removing and fastening the seat cushion

1) Lay the seat cushion onto the seat upholstery and secure it against sliding by pressing it onto the hook-and-
loop fastener (see fig. 21).
2) To remove, detach the seat cushion from the hook-and-loop closure on the seat upholstery.
21

7.4.2 Removing and fastening the back support pad

The back padding can be removed from the wheelchair for cleaning.
Removing the back support pad
1) Remove the seat cushion.
2) Pull the flap of the back support pad off the seat upholstery (see fig. 22).
3) Fold the back support pad to the rear and pull it off the hook-and-loop straps of the back support upholstery
(not illustrated).
Fastening the back support pad
1) From the rear, apply the edge of the back support pad to the upper hook-and-loop strap.
2) Fold down the back support pad and secure it to the upholstery straps with the hook-and-loop fasteners (see
fig. 23).
3) Pull the part of the flap that can be fastened forward and attach it to the seat upholstery with the hook-and-loop
fastener (see fig. 22).
22

7.5 Backrest

WARNING
Incorrect use of back support angle adjustment
Falling, tipping over due to operation without anti-tipper
► Note that adjusting the back support angle shifts the centre of gravity. Only use the back support angle
adjustment with the anti-tipper activated.
► Drive in street traffic only with a vertical back support.
The product can be equipped with a fixed or optionally an angle-adjustable backrest.
20
23
Start M4 XXL, Start M6 Junior