Adjusting The Leg Supports; Seat And Back Upholstery; Removing And Fastening The Seat Cushion; Removing And Fastening The Back Support Pad - Otto Bock Motus CV Instructions For Use Manual

25

7.3.5 Adjusting the leg supports

Further adjustments may be made only by qualified personnel.

7.4 Seat and back upholstery

WARNING
Seat cushions and back support pads may ignite
Burns due to user error
► The seat and back support upholstery as well as seat cushions, padding and covers fulfil the normative
requirements for flame resistance. However, they may still ignite if fire is handled improperly or negligently.
► Keep away from all ignition sources, especially lit cigarettes.
CAUTION
Wear of the seat and back upholstery
Loss of functionality due to prohibited continued use
► Have the seat and back upholstery replaced immediately in case of damage.
The product is equipped with seat and back upholstery. Hook-and-loop fasteners on the seat upholstery are used
to attach the seat cushion. The seat cushion ensures pressure relief during use of the wheelchair. It was chosen by
qualified personnel according to the needs of the user.

7.4.1 Removing and fastening the seat cushion

The seat cushion can be removed for cleaning.
1) Secure the seat cushion against sliding on the seat upholstery by pressing it onto the hook-and-loop fastener
(see fig. 8).
2) To detach the seat cushion, loosen it from the hook-and-loop fastener of the seat upholstery.

7.4.2 Removing and fastening the back support pad

7.4.2.1 Back upholstery, adaptable

The "adaptable" back support pad can be detached from the wheelchair for cleaning.
Detaching the back support pad
1) Detach the seat cushion (see fig. 8).
2) Pull the flap of the back support pad off the seat upholstery (see fig. 27).
3) Detach the back support pad from the hook-and-loop straps of the back support upholstery (see fig. 28).
Attaching the back support pad
1) From the rear, place the edge of the back support pad on the upper hook-and-loop strap (see fig. 29).
2) Fold down the back support pad and secure it to the upholstery straps with the hook-and-loop fasteners (see
fig. 28).
3) Pull the hook-and-loop section of the flap forward and attach it to the seat upholstery (see fig. 30).
Motus CV, Motus CS
26
Use
19