Seat And Back Upholstery; Removing And Installing The Seat Upholstery; Removing And Installing The Back Support Upholstery; Seat Cushion - Otto Bock Centro S1 Instructions For Use Manual

9.4 Seat and back upholstery

WARNING
Seat cushions and back support pads may ignite
Burns due to user error
► The seat and back support upholstery as well as seat cushions, padding and covers fulfil the normative
requirements for flame resistance. However, they may still ignite if fire is handled improperly or negligently.
► Keep away from all ignition sources, especially lit cigarettes.
CAUTION
Wear of the seat and back upholstery
Loss of functionality due to prohibited continued use
► Have the seat and back upholstery replaced immediately in case of damage.
The product is equipped with seat and back upholstery. This ensures pressure relief during use of the wheelchair.

9.4.1 Removing and installing the seat upholstery

The seat upholstery can be removed from the wheelchair for cleaning.
Removing the seat upholstery
1) Remove the Phillips head screws on each side (see fig. 22).
2) Remove the seat upholstery.
Installing the seat upholstery
1) Lay the seat upholstery onto the frame tubes.
2) Install and tighten the Phillips head screws on each side (see fig. 22).
22

9.4.2 Removing and installing the back support upholstery

The back upholstery can be removed from the wheelchair for cleaning.
Removing the back upholstery
1) Remove the Phillips head screws on each side (see fig. 23, item 1).
2) Remove the back upholstery.
Installing the back upholstery
1) Hold the back upholstery against the frame tubes.
2) Install and tighten the Phillips head screws on each side (see fig. 23, item 1).

9.5 Seat cushion

The seat cushion can be removed for cleaning.
After cleaning, the seat cushion is placed on the seat upholstery and secured against sliding by pressing it onto the
hook-and-loop fastener on the seat upholstery.
Centro S1
23
Use
21