Table of Contents
Advertisement
Settings and assembly instructions
7.7 Adjusting the anti-tipper
CAUTION
Incorrect installation of the anti-tipper
Tipping over, falling of the user due to incorrect adjustment
► Verify that the anti-tipper has been installed and adjusted properly. Find the appropriate position with the
assistance of a helper.
The anti-tipper wheel is height-adjustable within a narrow range.
1) Open the hook-and-loop closure of the protective pad and remove the protective pad (see fig. 49).
2) Use a screwdriver to pry open the cap on the housing (not illustrated).
3) Loosen the Allen head screw in the housing (see fig. 39, item 1/2).
4) Pull the swivel axle down and out of the housing.
5) Place a washer onto the ball bearings in order to change the ground clearance.
6) Insert the swivel axle.
7) Install the Allen head screw in the housing (see fig. 39, item 1/2).
8) Close the housing.
9) Attach the protective pad and fasten the hook-and-loop closure (see fig. 49).
7.8 Attaching the seat belts
WARNING
Improper installation of the seat belts
Strangulation, suffocation due to failure to observe specifications
► Observe the information in the instructions for use included with the seat belt for installation.
► The correct positioning of all retainers in terms of orientation and tension of the seat belts is very important so
that the user is held securely in accordance with their disability.
The installation instructions below provide a brief overview of seatbelt installation. Comprehensive information on
the respective installation is found in the instructions for use included with the seatbelts.
Lower leg strap, thigh strap
1) Pull the strap pads to the inside (see fig. 17, item 1).
2) Open the hook-and-loop strap which is now exposed.
3) Loop the straps around the frame tube (see fig. 17, see 2).
4) Fasten the hook-and-loop straps.
5) Push the strap pads to the outside, up against the frame tubes.
17
Lap belt
1) Pull the strap ends through between the seat bottom and side panel (see fig. 18; see fig. 19, item 1).
2) Slide the clamp fittings onto the back tube (see fig. 19, item 2).
3) Screw the strap ends to the clamp fittings (see fig. 19, item 3).
18
Invader 480S26=20000_K
Advertisement
Table of Contents
