Table of Contents
Advertisement
•
Body weight of user
•
Tyres (air pressure, tyre tread depth)
7.7.7 Anti-tipper
The anti-tipper rollers stabilise the power wheelchair when braking while driving downhill.
The anti-tipper is mounted so that the ground clearance is at least 50 mm.
7.7.8 Drive-away lock
INFORMATION
This function is enabled.
For questions regarding deactivation, please consult the qualified personnel that adapted the product or the man
ufacturer's service (see inside back cover or back page for addresses).
The power wheelchair control unit features an electronic drive-away lock. This function is activated/deactivated via
the control panel.
Activating the drive-away lock
1) Press and hold the [On/off] switch while the control unit is turned on.
2) Release the [On/off] button after a beep sounds (approx. 1 second).
3) Push the joystick all the way forward until a beep sounds.
4) Push the joystick all the way back until a beep sounds.
→ A long beep confirms that the drive-away lock was activated.
→ The control unit turns itself off.
→ A sequential indicator on the [Selected speed level] LED display indicates that the drive-away lock is active:
Display
Sequential indicator on the "Speed levels"
LED display
Deactivating the drive-away lock
When the unit is turned on, the [Charge level] LED display is off and the [Selected speed level] LED indicator is in
sequential indicator mode.
1) Push the joystick all the way forward until a beep sounds.
2) Push the joystick all the way back until a beep sounds.
3) Release the joystick.
→ A long beep confirms that the driving function is enabled.
→ The [Charge level] LED indicator is lit.
→ The drive-away lock is deactivated and driving is enabled.
Troubleshooting
The drive-away lock remains active if the deactivation movement is not completed correctly.
1) Turn the control device off in order to deactivate the drive-away lock again.
2) Turn the power wheelchair on.
3) Deactivate the drive-away lock again.
7.7.9 Adapting the driving characteristics
WARNING
Incorrect configuration of the control device
Falling, tipping over, collision due to incorrect parameter settings
► The parameter settings of the control device may only be changed by qualified personnel. The manufacturer of
the product and the control device manufacturer are not liable in case of damage caused by parameter set
tings that were incorrectly configured or not adjusted properly according to the user's abilities.
Adjusting and setting the speed, acceleration and deceleration values to the individual user requirements is per
formed exclusively by the qualified personnel.
490E163=*
Information
Drive-away lock
Use
23
Advertisement
Table of Contents
