Installing And Adjusting The Anti-Tipper; Installing The Anti-Tipper; Adjusting The Anti-Tipper; Installing And Adjusting The Lap Belt - Otto Bock Centro S1 Instructions For Use Manual

Table of Contents

With this wheelchair type, the armrest height cannot be adjusted.

7.9 Installing and adjusting the anti-tipper

CAUTION

Incorrect installation of the anti-tipper

Tipping over, falling of the user due to incorrect adjustment

► Verify that the anti-tipper has been installed and adjusted properly. Find the appropriate position with the

assistance of a helper.

Depending on the order, the anti-tipper was included with the overall product.

Installing the anti-tipper is highly recommended for untrained users. The following steps are required for installa

tion:

1) Cut open the end cap on the frame tube and remove (see fig. 13).

2) Press in the push-button on the upper tube section of the anti-tipper (see fig. 14, item 1).

3) Slide the anti-tipper into the frame tube until the tripod spring snaps into place automatically.

The length of the anti-tipper does not have to be separately adjusted after installation on this wheelchair model.

CAUTION

Incorrect approach to the adjustment process

Injuries, malpositions, user discomfort due to adjustment errors

► The qualified personnel is responsible for the individual positioning and fitting of the belt system.

► Adjusting the belt system too tightly may lead to unnecessary pain or user discomfort.

► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the

fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).

Centro S1

Settings and assembly instructions

Table of Contents