Configuring The General Media Settings; Figure 5-45: General Media Settings Screen; Table 5-31: Media Settings, Hook-Flash Settings Parameters - AudioCodes Mediant 1000 User Manual
Sip media gateways
Hide thumbs
Also See for Mediant 1000:
- User manual (1195 pages) ,
- Hardware installation manual (84 pages) ,
- Installation manual (76 pages)
Table of Contents
Advertisement
Table 5-31: Media Settings, Hook-Flash Settings Parameters
Parameter
Min. Flash-Hook Detection Period
[msec]
[MinFlashHookTime]
Max. Flash-Hook Detection Period
[msec]
[FlashHookPeriod]
5.6.2.5
Configuring the General Media Settings
To configure the General Media Settings parameters, take these 4
steps:
1.
Open the 'General Media Settings' screen (Advanced Configuration menu > Media
Settings > General Media Settings option); the 'General Media Settings' screen is
displayed.
2.
Configure the General Media Settings according to
3.
Click the Submit button to save your changes.
4.
To save the changes so they are available after a power fail, refer to Section
page 200.
SIP User's Manual
Description
Sets the minimal time (in msec) for detection of a flash-hook event (for
FXS only).
The valid range is 25 to 300. The default value is 300 msec.
Detection is guaranteed for flash hook periods of at least 60 msec (when
setting the minimal time to 25). Flash-hook signals that last a shorter
period of time are ignored.
Note: It's recommended to reduce the detection time by 50 msec from
the desired value (e.g. if you set the value to 200 msec, then enter 150
msec (i.e. 200 minus 50).
Defines the flash-hook period (in msec) for both analog and IP sides.
For the analog side it defines the following:
Maximal hook-flash detection period (for FXS gateways). A longer
signal is considered offhook / onhook event.
Hook-flash generation period (for FXO gateways).
For the IP side it defines the flash-hook period that is reported to IP.
The valid range is 25 to 1500. The default value is 700 msec.
Note: For FXO gateways, a constant of 90 msec must be added to the
required hook-flash period. For example, to generate a 450 msec hook-
flash, set 'FlashHookPeriod' to 540.
Figure 5-45: General Media Settings Screen
158
Mediant 1000
Table
5-32.
Document #: LTRT-83301
5.9.2
on
Advertisement
Table of Contents
