Metering Tones; Figure 5-11: Metering Tones Parameters Screen; Table 5-9: Metering Tones Parameters - AudioCodes Mediant 1000 User Manual

SIP User's Manual
5.5.2.3

Metering Tones

FXS modules can generate 12/16 KHz metering pulses towards the Tel side (e.g., for
connection to a payphone or private meter). Tariff pulse rate is determined according to an
internal table. This capability enables users to define different tariffs according to the
Source / Destination numbers and the Time-of-Day. The tariff rate includes the time interval
between the generated pulses and the number of pulses generated on answer.
To configure the Metering Tones, take these 6 steps:
1. Open the 'Metering Tones' screen (Protocol Management menu > Advanced
Parameters submenu > Metering Tones option); the 'Metering Tones' screen is
displayed.
2. In the field 'Metering Tone Type', select the type of the metering tone according to
your requirements (refer to
3. In the field 'Generate Metering Tones', select the method used to configure the
metering tones that are generated to the Tel side (refer to
•
If you selected 'Internal Table' in the field 'Generate Metering Tones', you must
configure the 'Charge Codes Table'. To configure the 'Charge Codes Table', refer
to Section
•
The 'RADIUS' option is not supported in the current version.
4. In the Tel to IP Routing table (Section
to
When a new call is established, the Tel to IP Routing table is searched for the
destination IP addresses. Once a route is found, the Charge Code (configured for that
route) is used to associate the route with an entry in the Charge Codes table.
5. Click the Submit button to save your changes.
6. To save the changes so they are available after a power fail, refer to Section
page 200.
Parameter
Generate Metering Tones
[PayPhoneMeteringMode]
Version 5.0

Figure 5-11: Metering Tones Parameters Screen

Table
5.5.2.3.1 below. Continue with step 4.
the routing

Table 5-9: Metering Tones Parameters

Description
Determines the method used to configure the metering tones that are generated to
the Tel side (FXS modules only).
Disable [0] = Metering tones aren't generated (default).
Internal Table [1] = Metering tones are generated according to the internal table
configured by the parameter ChargeCode.
RADIUS [2] = N/A.
Note: This parameter is not applicable to the Metering Tones Relay mechanism
(described in Section 13.1
5-9).
5.5.4.2 on page 107) assign a charge code rule
rules
on page 339).
95
5. Web Management
Table 5-9).
you require.
5.9.2
December 2006
on