Status & Diagnostics; Gateway Statistics; Ip Connectivity - AudioCodes Mediant 1000 User Manual

5.7 Status & Diagnostics
Use this menu to view and monitor the gateway's channels, Syslog messages, hardware /
software product information, and to assess the gateway's statistics and IP connectivity
information.
5.7.1

Gateway Statistics

Use the screens under Gateway Statistics to monitor real-time activity such as IP
Connectivity information, call details and call statistics, including the number of call
attempts, failed calls, fax calls, etc.
Note:
5.7.1.1

IP Connectivity

The IP Connectivity screen provides you with online read-only network diagnostic
connectivity information on all destination IP addresses configured in the Tel to IP Routing
table (refer to Section
Notes:
To view the IP connectivity information, take these 2 steps:
1. Set the parameter 'Enable Alt Routing Tel to IP' (or ini file parameter
AltRoutingTel2IPEnable) to 'Enable' (1) or 'Status Only' (2). To configure this
parameter, refer to Section
2. Open the 'IP Connectivity' screen (Status & Diagnostics menu > Gateway Statistics
submenu > IP Connectivity); the 'IP Connectivity' screen is displayed
SIP User's Manual
The Gateway Statistics screens don't refresh automatically. To view
updated information, re-access the screen you require.
5.5.4.2 on page 107).
•
This information is available only if the parameter
AltRoutingTel2IPEnable (described in
or 2 (Status Only).
•
The information in columns 'Quality Status' and 'Quality Info.' (per IP
address) is reset if two minutes elapse without a call to that
destination.
5.5.4.1
184
Table
on page 105.
Mediant 1000
5-14) is set to 1 (Enable)
(Figure 5-58).
Document #: LTRT-83301