Configuring The Voice Mail (Vm) Parameters; Figure 5-32: Voice Mail Screen - AudioCodes Mediant 1000 User Manual

SIP User's Manual
Table 5-18: FXO Parameters (continues on pages 127 to 129)
Parameter
Guard Time Between Calls
[GuardTimeBetweenCalls]
5.5.8

Configuring the Voice Mail (VM) Parameters

Use this screen to configure the Voice Mail (VM) parameters. The VM application applies
only to FXO/CAS modules. For detailed information on VM, refer to the CPE Configuration
Guide for Voice Mail.
To configure the VM parameters, take these 4 steps:
1. Open the 'Voice Mail' screen (Protocol Management menu > FXO Settings > Voice
Mail option); the 'Voice Mail' screen is displayed.
2. Configure the Voice Mail parameters according to
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
page 200.
Version 5.0
Description
Defines the time interval (in seconds) after a call has ended and a new call can be
accepted for IP to Tel calls.
Applicable only to FXO modules.
The valid range is 0 to 10. The default value is 1 second.
Note: Occasionally, after a call is ended and onhook is applied, a delay is required
before placing a new call (and performing offhook). This is necessary to prevent
wrong hook-flash detection or other glare phenomena.

Figure 5-32: Voice Mail Screen

129
5. Web Management
Table 5-19.
December 2006
5.9.2 on