AudioCodes Mediant 1000 User Manual page 489

SIP User's Manual
4. Continue with the installation, going through the following screens:
•
'Partition disks'
•
'Installing the Debian base system'
5. In the 'Install the GRUB boot loader on hard disk' screen, select Go Back. This returns
you to the 'Debian installer main menu' screen. This is the main menu of the
installation.
6. Scroll down in the menu and instead of using GRUB select Install LILO boot loader
on a hard disk.
7. In the 'LILO Installation target', select /dev/hda: Master Boot Record.
Note:
8. In the next screen, the installation should display the following:
LILO is configured to use serial port ttyS0 as the console.
The serial port speed is set to 115200.
9. Select Continue.
The 'Finish the installation' screen should appear followed by 'Installation complete'.
10. The installation should eject the CD. Please remove the CD and close the tray.
The system reboots and after the BIOS phase you should see the kernel being
uncompressed.
11. Now the installation has finished its "base" phase. The 'Debian Configuration' screen
should appear. This is the phase where you select additional packages to be installed
and where they are going to be installed from.
Note:
12. After the whole installation has been completed, you will be able login to the system
from the serial console and/or to "ssh" on your Mediant 1000 (to create an SSH
remote connection to it) and to continue its post-installation configuring. You can use
the boot media you have created in order to install multiple Mediant 1000 stations.
Version 5.0
L. Linux™ Operating System Installation for the OSN Server
The bootloader should detect the serial console. If it doesn't then either.
a) pass additional parameters to the kernel (configure that using the main
installation menu)
or/and
b) when configuring LILO you should specify that it tells the kernel to use
serial console at speed 115200. In other words append
"text console=ttyS0,115200" to the kernel options using LILO.
If the serial console wasn't detected during installation, add the following
line to the LILO's configuration file after the installation:
"serial=0,115200"
Ensure that you install telnet and that the ssh packages get installed, so
that you can connect to your newly-installed system in the future (usually
installed by default). From this point on you should proceed as instructed
by your Linux distributor.
489 December 2006