Table 5-29: Media Settings, Fax/Modem/Cid Parameters (Continues On Pages 153 To 154) - AudioCodes Mediant 1000 User Manual

Table 5-29: Media Settings, Fax/Modem/CID Parameters (continues on pages 152 to 153)
Parameter
Fax Transport Mode
[FaxTransportMode]
Caller ID Transport Type
[CallerIDTransportType]
Caller ID Type
[CallerIDType]
V.21 Modem Transport Type
[V21ModemTransportType]
V.22 Modem Transport Type
[V22ModemTransportType]
V.23 Modem Transport Type
[V23ModemTransportType]
V.32 Modem Transport Type
[V32ModemTransportType]
SIP User's Manual
Description
Fax Transport Mode that the gateway uses.
You can select:
Disable [0] (transparent mode).
T.38 Relay [1] (default).
Bypass [2].
Events Only [3].
Note: If parameter IsFaxUsed = 1, then FaxTransportMode is always set to
1 (T.38 relay).
N/A.
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID and detection (FXO) of MWI (when specified) signals.
Bellcore [0] (Caller ID and MWI) (default).
ETSI [1] (Caller ID and MWI)
NTT [2].
British [4]
DTMF ETSI [16]
Denmark [17] (Caller ID and MWI)
India [18]
Brazil [19]
Note 1: The Caller ID signals are generated/detected between the first and
the second rings.
Note 2: To select the Bellcore Caller ID sub standard, use the parameter
'BellcoreCallerIDTypeOneSubStandard'. To select the ETSI Caller ID sub
standard, use the parameter 'ETSICallerIDTypeOneSubStandard'.
Note 3: To select the Bellcore MWI sub standard, use the parameter
'BellcoreVMWITypeOneStandard'. To select the ETSI MWI sub standard,
use the parameter 'ETSIVMWITypeOneStandard'.
V.21 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent) -- default
1 = Enable Relay – N/A
2 = Enable Bypass
3 = Events Only (Transparent with Events)
V.22 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
V.23 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
V.32 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
Note: This option applies to V.32 and V.32bis modems.
152
Mediant 1000
Document #: LTRT-83301