Figure 5-34: Trunk Group Settings Screen - AudioCodes Mediant 1000 User Manual

SIP User's Manual
To configure the Trunk Group Settings table, take these 7 steps:
1. Open the 'Trunk Group Settings' screen (Protocol Management menu > Trunk
Group Settings); the 'Trunk Group Settings' screen is displayed.
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. In the 'Trunk Group ID' field, enter the Trunk Group ID number.
4. From the 'Channel Select Mode' drop-down list, select the Channel Select Mode that
determines the method in which new calls are assigned to channels within the Trunk
groups entered in the field to the right of this field. For information on available
Channel Select Modes, refer to
5. Repeat steps 3 and 4, for each defined Trunk group.
6. Click the Submit button to save your changes.
7. To save the changes so they are available after a power fail, refer to Section
page 200.
Version 5.0

Figure 5-34: Trunk Group Settings Screen

Table
133
5-21.
5. Web Management
5.9.2 on
December 2006