Advanced Configuration; Configuring The Network Settings - AudioCodes Mediant 1000 User Manual

Table 5-22: Digital Gateway Parameters (continues on pages 136 to 138)
Parameter
Remove CLI when Restricted
[RemoveCLIWhenRestricted]
Add Prefix to Redirect Number
[Prefix2RedirectNumber]
5.6

Advanced Configuration

Use this menu to set the gateway's advanced configuration parameters.
Note:
5.6.1

Configuring the Network Settings

From the Network Settings you can:
Configure the IP Settings (refer to Section
Configure the Application Settings (refer to Section
Configure the NFS Settings (refer to Section
Configure the IP Routing Table (refer to Section
Configure the VLAN Settings (refer to Section
SIP User's Manual
Description
Determines (for IP to Tel calls) whether the Calling Number IE and Calling
Name IE are removed from the outgoing ISDN Setup message if the
presentation is set to Restricted.
0 = IE aren't removed (default).
1 = IE are removed.
Defines a string Prefix that is added to the Redirect number received from
the Tel side. This Prefix is added to the Redirect Number in the Diversion
header.
The valid range is an 8 character string. The default is an empty string.
Parameters contained within square brackets are the names used to
configure the parameters via the ini file.
138
5.6.1.1 below)
5.6.1.2 on page 142)
5.6.1.3 on page 143)
5.6.1.4 on page 145)
5.6.1.5 on page 147)
Document #: LTRT-83301
Mediant 1000