Dtmf & Dialing Parameters; Figure 5-8: Dtmf & Dialing Screen; Table 5-6: Dtmf & Dialing Parameters (Continues On Pages 80 To 82) - AudioCodes Mediant 1000 User Manual

5.5.1.4 DTMF & Dialing Parameters
Use this screen to configure parameters that are associated with DTMF and dialing.
To configure the dialing parameters, take these 4 steps:
1. Open the 'DTMF & Dialing' screen (Protocol Management menu > Protocol
Definition submenu > DTMF & Dialing option); the 'DTMF & Dialing' screen is
displayed.
2. Configure the DTMF & Dialing parameters according to
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
page 200.
Table 5-6: DTMF & Dialing Parameters (continues on pages 80 to 82)
Parameter
Max Digits in Phone Num
[MaxDigits]
SIP User's Manual
Figure 5-8: DTMF & Dialing Screen
Description
Defines the maximum number of collected destination number digits received from
the Tel side (ISDN uses overlap dialing). When the number of collected digits
reaches the maximum, the gateway uses these digits for the called destination
number.
The valid range is 1 to 49. The default value is 30.
Note 1: Dialing ends when the maximum number of digits is dialed, the Interdigit
Timeout expires, the '#' key is dialed, or a digit map pattern is matched.
Note 2: Digit Mapping Rules can be used instead.
80
Mediant 1000
Table 5-6.
5.9.2
Document #: LTRT-83301
on