Figure 5-38: Nfs Settings Table Screen; Document #: Ltrt-83301 Mediant - AudioCodes Mediant 1000 User Manual

To configure the NFS Settings parameters, take these 7 steps:
1. Open the 'Application Settings' screen (Advanced Configuration menu > Network
Settings > Application Settings option); the 'Application Settings' screen is
displayed
2. Open the NFS Table screen by clicking the arrow sign (-->) to the right of the NFS
label; the NFS Table screen is displayed
3. To add a remote NFS file system, select an available line number from the 'Line
Number' drop-down list.
4. Click the Add an Empty Line button; an empty line appears.
5. Configure the NFS Settings according to
6. Click the Apply New Settings button; the remote NFS file system is mounted
immediately. Check the Syslog server for the 'NFS mount was successful' message.
7. To save the changes so they are available after a power fail, refer to Section
page 200.
Note:
To delete a remote NFS file system, take these 3 steps:
1. Select the Edit radio button for the row to be deleted.
2. Click the Delete Line button; the row is deleted.
3. To save the changes so they are available after a power fail, refer to Section
page 200.
To modify an existing remote NFS file system, take these 4 steps:
1. Select the Edit radio button for the row to be modified.
2. Change the values on the selected row according to your requirements.
3. Click the Apply New Settings button; the remote NFS file system is mounted using
the new settings. Check the Syslog server for the 'NFS mount was successful'
message.
4. To save the changes so they are available after a power fail, refer to Section
page 200.
SIP User's Manual
(Figure 5-37).

Figure 5-38: NFS Settings Table Screen

To avoid terminating calls in progress, a row must not be deleted or
modified while the board is currently accessing files on that remote NFS file
system.
144
(Figure 5-38).
Table 5-25.
Document #: LTRT-83301
Mediant 1000
5.9.2 on
5.9.2 on
5.9.2 on