Configuring The Fxo Parameters; Figure 5-31: Fxo Settings Screen - AudioCodes Mediant 1000 User Manual

2. In the 'Caller ID' field, select one of the following:
•
Enable: Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
•
Disable: Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
•
Empty: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter 'EnableCallerID' (described in
3. Repeat Step 2 for each port.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail, refer to Section
page 200.
5.5.7

Configuring the FXO Parameters

Use this screen to configure the gateway's specific FXO parameters.
To configure the FXO parameters, take these 4 steps:
1. Open the 'FXO Settings' screen (Protocol Management menu > FXO Settings >
FXO Settings option); the 'FXO Settings' screen is displayed.
2. Configure the FXO parameters according to
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
page 200.
SIP User's Manual

Figure 5-31: FXO Settings Screen

126
Table 5-18.
Document #: LTRT-83301
Mediant 1000
Table 5-8).
5.9.2 on
5.9.2 on