Configuring The Bootp Clients; Adding Clients - AudioCodes Mediant 1000 User Manual

SIP User's Manual
D.11 Configuring the BootP Clients
The Clients window, shown in
specific VoIP gateway.
D.11.1 Adding Clients
Adding a client creates an entry in the BootP Tool for a specific gateway.
To add a client to the list without using a template, take these 3
steps:
1. Click the Add New Client icon
2. Enter values in the fields on the right side of the window, using the guidelines for the
fields in Section
3. Click Apply to save this entry to the list of clients, or click Apply & Reset to save this
entry to the list of clients and send a reset message to that gateway to immediately
implement the settings.
Note: To use Apply & Reset you must enable ARP Manipulation in the Preferences
window. Also, you must have administrator privileges for the computer you are using.
An easy way to create several clients that use similar settings is to create a template. For
information on how to create a template, refer to Section
Version 5.0
Figure D-4
Figure D-4: Client Configuration Screen
D.11.5 on page 421.
419
D. BootP/TFTP Configuration Utility
below, is used to set up the parameters for each
; a client with blank parameters is displayed.
D.12 on page 424.
December 2006