AudioCodes Mediant 1000 User Manual page 375

SIP User's Manual
acAlarm: This is AudioCodes' proprietary carrier-grade alarm MIB. It is a simpler
implementation of the notificationLogMIB and the IETF suggested alarmMIB (both also
supported in all AudioCodes' devices).
The acAlarm MIB has the following groups:
•
ActiveAlarm: straightforward (single-indexed) table, listing all currently active
alarms, together with their bindings (the alarm bindings are defined in acAlarm.
acAlarmVarbinds and also in acBoard.acTrap. acBoardTrapDefinitions.
oid_1_3_6_1_4_1_5003_9_10_1_21_2_0).
•
acAlarmHistory: straightforward (single-indexed) table, listing all recently raised
alarms together with their bindings (the alarm bindings are defined in acAlarm.
acAlarmVarbinds and also in acBoard.acTrap. acBoardTrapDefinitions.
oid_1_3_6_1_4_1_5003_9_10_1_21_2_0).
The table size can be altered via
notificationLogMIB.notificationLogMIBObjects.nlmConfig.nlmConfigGlobalEntryLimit or
notificationLogMIB.notificationLogMIBObjects.nlmConfig.nlmConfigLogTable.nlm
ConfigLogEntry.nlmConfigLogEntryLimit.
The table size can be any value between 50 and 1000 (default is 500).
Note 1:
Note 2:
Version 5.0
The following are special notes pertaining to MIBs:
•
A detailed explanation of each parameter can be viewed in an
SNMP browser in the "MIB Description" field.
•
Not all groups in the MIB are functional. Refer to version release
notes.
•
Certain parameters are non-functional. Their MIB status is marked
"obsolete".
•
When a parameter is set to a new value via SNMP, the change may
affect device functionality immediately or may require that the
device be soft reset for the change to take effect. This depends on
the parameter type.
The current (updated) device configuration parameters are programmed
into the device provided that the user does not load an ini file to the device
after reset. Loading an ini file after reset overrides the updated parameters.
16. SNMP-Based Management
375 December 2006