Rear Brake Caliper Removal And Installation - Suzuki GSF650A Service Manual

4C-3 Rear Brakes:
7) Install the new brake pads.
NOTE
Make sure that the detent of the pad is seated
onto the retainer on the caliper bracket.
8) Tighten the caliper mounting bolt (7) and pad
mounting pin (8) to the specified torque.
Tightening torque
Rear brake caliper mounting bolt (a): 22 N·m (
2.2 kgf-m, 16.0 lbf-ft)
Rear brake pad mounting pin (b): 17 N·m (1.7
kgf-m, 12.5 lbf-ft)
8
(b)
7
(a)
9) Install the plug (9) to the specified torque.
Tightening torque
Pad pin plug (c): 2.5 N·m (0.25 kgf-m, 1.8 lbf-ft)
NOTE
After replacing the brake pads, pump the
brake pedal few times to check for proper
brake operation and then check the brake
fluid level.

Rear Brake Caliper Removal and Installation

Removal
1) Drain brake fluid. Refer to "Brake Fluid Replacement
I717H1430005-01
in Section 4A (Page 4A-7)".
2) Remove the brake hose from the caliper by
removing the union bolt (1) and catch the brake fluid
in a suitable receptacle.
NOTE
• Place a rag underneath the union bolt on
the brake caliper to catch any spilt brake
fluid.
• Slightly loosen the sliding pin (2) to
facilitate later disassembly, if necessary.
I717H1430006-01
3) Remove the brake pads. Refer to "Rear Brake Pad
Replacement (Page 4C-2)".
4) Pivot the caliper up and remove the caliper from the
caliper bracket.
9
(c)
I717H1430007-01
B817H24306004
1
2
I717H1430008-01
I717H1430009-01